Snap-on 5000-3 Instrukcja Użytkownika Pobierz pdf (Strona 25)

SETUP AND PROGRAMMING CHAPTER 3

Setting Up the CDI 5000-3 Torque Calibration System

1. Bolt the loader to a sturdy location.

2. Install Pivot tube, Extension arm and Bracket. Adjust to desired position then lock using three

setscrews shown on Fig. 3-2.

3. Install the SURETEST unit to the bracket and lock the unit using the two side knobs.

4. Install slide assembly (2100-0018), then lock using the side knobs as shown on Fig. 3-3.

5. Install the appropriate transducer or standoff (for 4-in-1) to the loader drive.

6. Install two quick release pins, part number 2000-195-13.

7. For 4-in-1 unit, install 4-in-1 bracket (2000-500-02) to the standoff as shown of Fig. 3-3 and

insert two quick release pins (2000-195-13). Slide 4-in-1 (2000-400-02) on the bracket and

align the selected transducer over the loader drive. Tighten the left knob first, then the top

knob.

Note: To use the two small transducers, remove the 4-in-1, rotate 180 degrees, and reinsert.

8. Connect the transducer cable, part number 2000-900-120, between the SURETEST and

transducer.

9. Install the safety shield to the front of the 600TL.

10. Pull Extension tube (to test wrench with extension) as shown on Fig. 3-2 until lock pins snap.

For testing procedures refer to Chapter 4—Using the Torque Tester.

3-2

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

Brak uwag

Snap-on 5000-3 Instrukcja Użytkownika Strona 25